How to Fix a Whirlpool Washer Stuck on Sensing

How to Fix a Whirlpool Washer Stuck on Sensing

Fixing a Whirlpool washer stuck on “Sensing” can be frustrating, but it’s often a manageable issue that you can resolve without the need for professional assistance. When your washer gets stuck on the “Sensing” stage, it means it’s having trouble detecting the load and water level. Here’s a step-by-step guide to help you troubleshoot and resolve this problem:

Pause and Restart the Cycle:

Sometimes, a temporary glitch can cause the washer to get stuck. Try pausing the cycle and then restarting it by pressing the “Pause” or “Cancel” button. This can reset the washer’s internal sensors and may resolve the issue.

Check Water Supply:

Ensure that the water supply to the washer is turne on and that there is adequate water pressure. Low water pressure can prevent the washer from filling properly, causing it to get stuck on “Sensing.”

Verify the Load Size:

Make sure you haven’t overloaded the washer or placed an unbalanced load inside. Overloading or unevenly distributed loads can confuse the sensors and prevent the washer from proceeding to the next stage.

Close the Door Securely:

Ensure that the washer door is securely close. Some models have a door lock mechanism, and if the door is not properly close, it won’t move on to the next cycle.

Clean the Water Inlet Valve:

Sediment and debris can clog the water inlet valve, restricting water flow into the machine. Turn off the water supply, disconnect the hoses, and clean the inlet valve screens with a brush or replace them if necessary.

Check for Kinks or Blockages:

Inspect the water hoses for kinks or blockages that may restrict water flow. Straighten any kinks and remove any debris if present.

Reset the Washer:

Unplug the washer from the power source for a few minutes and then plug it back in. This can sometimes reset the control board and resolve software glitches.

Run a Calibration Cycle:

Some Whirlpool models allow you to run a calibration cycle. Refer to your user manual to find out how to initiate this cycle. Calibration can help the washer’s sensors work more accurately.

Check the Water Level Pressure Switch:

The water level pressure switch is responsible for determining the water level in the drum. This switch is located inside the control panel. You may need to replace it if it’s faulty.

Test the Lid Switch:

If your Whirlpool washer has a lid switch, it may not be making proper contact. Test the switch for continuity using a multimeter. If it’s faulty, replace it.

Update Software (if applicable):

Some modern washers have software that can be update. Check Whirlpool’s official website for any available software updates for your specific model and follow the instructions to install them.

Call for Professional Help:

If you’ve try all the above step and your washer is still stuck on “Sensing,” it may indicate a more In this case, it’s advisable to contact a professional technician or Whirlpool customer service for diagnosis and repair.

In summary:

a Whirlpool washer stuck on “Sensing” can be resolve through a series of troubleshooting steps. Begin with simple checks and gradually move to more complex solutions. By following these steps, you can often identify and fix the problem, ensuring your washer operates smoothly once again.